Overview; Run Cables - Bang & Olufsen BeoVision Avant-55 User Manual

Set the maximum angle the television will turn on the motorised floor stand or wall
bracket. Remember to leave enough space around the television to allow it to turn freely.
If your television is mounted on the motorised table stand, it can be slightly tilted to
avoid disturbing reflections. For more information, press the red button in the on-screen
help and find 'Set a stand position'.
If the television is to be moved when mounted on the floor stand, it must be moved by
qualified personnel. Also, it is important that the stand is set in transport mode. When
placed in a new position, the stand must be calibrated again. Bring up Settings, then
Stand to set it up again.

Overview

Locate the connection panel and other important items:
1. Holes for mounting of a wall bracket.
2. Holes for mounting of a stand.
3. Covers for the connection panel. Slide the covers to the sides to reveal the
connection panel.
4. Standby indicator.
Depending on your setup, different stand or wall bracket covers may be used. See the
guide for your stand or wall bracket for information on how to mount such covers.

Run cables

Gather the cables from the upper and lower part of the panel, fasten them with cable ties
and run them upwards or downwards behind the cable holders depending on wall
bracket or stand placement. See the illustrated example.
When mounted on a motorised stand or wall bracket, make sure that there is enough
slack in the cables to allow the television to turn to either side or tilt before you fasten the
cables with cable ties to make a neat bundle.
12