Machine Operation; While Operating Machine - Ice i20NBT Operator's & Parts Manual

FILLING THE SOLUTION TANK
The machine is equipped with a hose fill-port (see
machine components, item #13) at the rear of
the machine, and a bucket fill-port (see machine
components, item #37)located under the recovery
tank. Before accessing the bucket fill-port make
sure that the recovery tank is empty.
Fill the solution tank to the "60L" level on the
solution tank sight gauge. When using the bucket
fill-port, stop filling when the level reaches the
bottom edge of the fill-port.
NOTE: When filling the solution tank with a
bucket, make sure that the bucket is clean. Do not
use the same bucket for filling and draining the
machine.
WARNING: Do not put any flammable
materials into solution tank. this can cause an
explosion or a fire. Only use recommended
cleaning chemicals. Contact your janitorial
supply distributor for recommendations on
properchemicals.

MACHINE OPERATION

WARNING: Do not operate machine
unless you have read and understand this
manual.
1. Lower squeegee assembly to the floor by
lowering the squeegee lift lever(see machine
components, item #27).
2. Lower the scrub head to the floor by stepping
on the scrub head lift pedal(see machine
components, item #16).
3. Turn the main power key switch(see machine
components, item #4) to the on (I) position.
4. Check the battery level meter (see machine
components, item #5), if the battery meter
is in the red, DO NOT continue to operate
the machine and recharge the batteries
immediately.
5. Check the solution flow indicator (see machine
components, item #6), adjust the solution flow
control switch to a desired flow rate.
NOTE: Solution will not begin to flow until
the control handle bail is pulled.
ICE i20NB / i20NBT / i20NBT-OB / i24BT
6. Turn on the vacuum motor switch(see machine
components, item #8).
7. Dirve Model i20NBT / i24BT : Turn on the brush
motor switch (see machine components, item
#7).
8. The brush assist model i20NB: Pull the control
handle bail(see machine components, item #28)
backwards to start scrubbing by moving the
machine forward.
The drive model i20NBT / i24BT: Pull the
control handle bail(see machine components,
item #28) backwards to start scrubbing. The
machine will automatically propel forward. To
reverse the drive model, simply push the control
handle bail forward. the speed can be adjusted,
Adjust the speed control knob (see machine
components, item #3) to a desired scrubbing
speed.
NOTE: 45-60 meters (150-200 ft)per minute is
the recommended scrubbing speed.
9. When more brush pressure is needed for
heavily soiled areas simply lift the down
pressure lever(see machine components, item
#14).
10. To stop scrubbing, release the control handle
bail, raise the scrub head and the squeegee
assembly.

WHILE OPERATING MACHINE

WARNING: Fire Or Explosion Hazard. Do
Not Pick Up Flammable Materials Or Reactive
Metals.
1. Go slow on inclines and slippery surfaces. Do
not operate the machine on inclines that exceed
5% (3°).
2. Do not keep the machine in the same position
with pad / brush spinning, keep the machine
moving to prevent damage to floor finish.
3. If the squeegee assembly leaves streaks on the
floor, raise the squeegee off the floor and wipe
the blades down with a damp cloth. Pre-sweep
the area to prevent leaving streaks on the floor.
4. Pour a recommended defoamer into the
recovery tank if excessive foam appears.
WARNING: Do not allow foam to enter
the float shut-off screen, vacuum motor
damage will result. Foam will not activate the
float shut-off screen.
OPERATOR MANUAL
7