Ack Character; Nak Character - Datalogic Magellan 800i Product Reference Manual

ACK Character

NOTE
Sets the ACK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries of less than
three digits with zeros, as in "005". To configure this feature, scan the "Enter/Exit Programming Mode' bar code above
to place the unit in Programming Mode, then the "Set ACK Character," followed by the digits from the Alphanumeric
Appendix C, Alphanumeric Pad
table in
the "Enter/Exit Programming Mode' bar code above.
031F(CR)

NAK Character

NOTE
Sets the NAK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries of less than
three digits with zeros, as in "005". To configure this feature, scan the "Enter/Exit Programming Mode' bar code above
to place the unit in Programming Mode, then the "Set NAK Character," followed by the digits from the Alphanumeric
Appendix C, Alphanumeric Pad
table in
the "Enter/Exit Programming Mode' bar code above.
0320(CR)
Product Reference Guide
Setting to previously defined characters
such as XON, XOFF, or host commands con-
flicts with normal operation of these char-
acters; 8-bit data is not recognized when
the Number of Data Bits = 7 ASCII charac-
ters or any hex value from 0 to FF.
representing your desired character. Exit programming mode by again scanning
DEFAULT SETTING FOR THIS FEATURE: 006
Setting to previously defined characters
such as XON, XOFF, or host commands con-
flicts with normal operation of these char-
acters; 8-bit data is not recognized when
the Number of Data Bits = 7 ASCII charac-
ters or any hex value from 0 to FF.
representing your desired character. Exit programming mode by again scanning
DEFAULT SETTING FOR THIS FEATURE: 021
Enter/Exit Programming Mode
Set ACK Character
Set NAK Character
37