Insignia NS-RNE4BWH8-C User Manual page 43

NS-RNE4BWH8-C_17-0680_User MAN_V2_ENG.fm Page 43 Monday, September 18, 2017 1:12 PM
PROBLEM
Surface units do not work
The words "CLOSE DOOR" flashes or
scrolls in the display
Oven temperature too hot or too
cold
Clock and timer do not work
Display goes blank
Oven door is crooked
Oven makes clicking noise
"F" and a number or letter flash in
the display
POSSIBLE CAUSES
There has been a main power supply
surge and/or a power interruption and
surge.
This is a normal condition. The "CLOSE
DOOR" is a reminder message to keep
the oven door closed during broil
mode.
Oven thermostat needs adjustment.
Plug on range is not completely
inserted in the electrical outlet.
A fuse in your home may be blown or
the circuit breaker tripped.
Oven controls improperly set.
A fuse in your home may be blown or
the circuit breaker tripped.
The clock is turned off from showing in
the display.
The door is out of position.
This is the sound of the heating
element turning off and on during
cooking functions.
You have a function error code.
If the function code repeats:
www.insigniaproducts.com
4-Burner Electric Range
WHAT TO DO
On the Control Panel, activate the Self Clean
mode (press the SELF CLEAN button)
Wait for 30 seconds and then press the OFF
button.
The cooktop should now be ready to operate.
This is normal. Keep oven door closed during
broil mode.
See the Adjust the oven thermostat–Easy to do
yourself! section.
Make sure electrical plug is plugged into a live,
properly grounded outlet.
Replace fuse or reset circuit breaker.
See the Using the clock, timer and convenience
outlet section.
Replace fuse or reset circuit breaker.
See the Using the clock, timer and convenience
outlet section.
Because the oven door is removable, it
sometimes gets out of position during
installation. To straighten the door, push down
on the high corner.
This is normal.
Press the OFF pad. Put the oven back into
operation.
Disconnect all power to the range for at least 30
seconds and then reconnect power. If the
function error code repeats, call for service.
On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check
the oven door latch. The latch may have been
moved, if only slightly, from the locked
position. Make sure the latch is moved to the
right as far as it will go. Press the OFF pad.
Allow the oven to cool for one hour. Put the
oven back into operation.
43