Storage Drawer Removal (On Some Models); Porcelain Enamel Cooktop (On Radiant Models); Painted Surfaces (On Some Models) - Insignia NS-RNE4BWH8-C User Manual

NS-RNE4BWH8-C_17-0680_User MAN_V2_ENG.fm Page 37 Monday, September 18, 2017 1:12 PM
To replace the cover:
1 Place it into groove of the light receptacle. Pull wire forward to the
center of the cover until it snaps into place.
2 Connect electrical power to the range.

Storage Drawer Removal (on some models)

To remove the storage drawer:
1 Pull the drawer out all the way.
2 Tilt up the front and remove it.
To replace the storage drawer:
1 Insert glides at the back of the drawer beyond the stop on range glide.
2 Lift the drawer if necessary to insert easily.
3 Let the front of the drawer down; then push in to close.

Porcelain Enamel Cooktop (on radiant models)

The porcelain enamel finish is sturdy but breakable if misused. This finish
is acid-resistant. However, any acidic foods spilled (such as fruit juices,
tomato or vinegar) should not be permitted to remain on the finish.
If acids spill on the cooktop while it is hot, use a dry paper towel or cloth
to wipe it up right away. When the surface has cooled, wash with soap and
water. Rinse well.
For other spills such as fat spatterings, wash with soap and water or
cleansing powders after the surface has cooled. Rinse well. Polish with a
dry cloth.

Painted Surfaces (on some models)

Painted surfaces include the sides of the range and the sides of the door
trim.
To clean the painted surfaces, use a hot, damp cloth with a mild detergent
suitable for these surfaces. Use a clean, hot, damp cloth to remove soap.
Dry with a dry, clean cloth.
Do not use steel-wood pads, commercial oven cleaners, cleaning powders
or other abrasive cleaners. They will damage the surface.
www.insigniaproducts.com
4-Burner Electric Range
37