EMC Connectrix DS-16M2 Installation And Service Manual page 357

3. Ensure that the power switch on the power supply is turned off,
the power lockout lever is rotated to the right, covering the AC
connector, and the black plastic latch lever is completely down in
the horizontal position.
4. Insert the power supply into the chassis until it stops.
Replacement steps 5-6 pertain to the DS-32M2 only.
5. Raise the black plastic latch lever to the vertical position.
The power supply cams into its seated position in the chassis.
6. Rotate the power lockout lever to the left to cover the plastic lever
and expose the AC connector.
7. Verifying that the power switch is off, connect the AC power cord
to the power supply and to a facility power source.
8. Turn on the power switch.
9. Inspect the power supply to ensure that the green LED is
illuminated. If the green LED is extinguished, go to MAP 0000:
Start MAP on page 3-7 to isolate the problem.
10. At the Connectrix Server's
option from the
Logs
following event code appear in the log:
— 203 - Power supply AC voltage recovery.
11. At the Connectrix Server's
supply graphic and ensure no alert symbols appear that indicate
a failure (yellow triangle or red diamond). If a problem is
indicated, go to MAP 0000: Start MAP on page 3-7 to isolate the
problem.
12. Perform the data collection procedure (Collecting Maintenance
Data on page 4-36).
13. Clear the switch system error (ERR) LED:
a. At the Connectrix Server's
panel bezel graphic (away from a FRU) to open a pop-up
menu.
b. Click the Clear System Error Light menu selection.
FRU Removal and Replacement
view, select the
Hardware
icon. The displays. Ensure the
Event Log
view, observe the power
Hardware
view, right-click the front
Hardware
Remove and Replace FRUs
5
Event Log
5-7