Card Reader/Audio Board - HP EliteBook 1050 G1 Maintenance And Service Manual

Card reader/audio board

Description
Card reader/audio board (includes cable)
Before removing the card reader/audio board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the right speaker (see
Remove the card reader/audio board:
1. Disconnect the cable from the card reader/audio board ZIF connector (1).
2. Remove the two Phillips M2.0×2.0 screws (2) that secure the board to the computer.
3. Lift the board out of the computer (3).
Reverse this procedure to install the card reader/audio board.
Bottom cover on page
Battery on page 31).
Bottom speakers on page
29).
43).
Component replacement procedures
Spare part number
L31572-001
45