Touchpad - HP EliteBook 1050 G1 Maintenance And Service Manual

TouchPad

Description
TouchPad
TouchPad cable
Before removing the TouchPad, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the TouchPad:
1. Disconnect the card reader/audio cable from the system board ZIF connector (1).
2. Remove the cable from the adhesive that secures it to the TouchPad (2).
3. Disconnect the TouchPad cable from the TouchPad ZIF connector (3).
4. Remove the cable from the adhesive that secures it to the TouchPad (4).
5. Disconnect the NFC antenna cable from the NFC board ZIF connector (5).
6. Remove the six Phillips M2.0×2.0 screws (1) that secure the TouchPad to the top cover.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Battery on page 31).
29).
Spare part number
L31559-001
L28668-001 (Cable Kit)