Solid-State Drive (M.2) - HP EliteBook 1050 G1 Maintenance And Service Manual

Solid-state drive (M.2)

Description
2-TB, TLC
1-TB, TLC
1-TB, MLC
512-GB, TLC
512-GB, self-encrypting drive (SED), OPAL 2, TLC
512-GB, FIPS, TLC
256-GB, TLC
256-GB, PCIe, self-encrypting drive (SED), OPAL 2
256-GB, SATA-3, self-encrypting drive (SED), OPAL 2
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the solid-state drive:
1. Lift the Mylar from atop the solid-state drive.
2. Remove the Phillips M2.0×3.0 screw (1) that secures the solid-state drive to the system board.
Bottom cover on page
Battery on page 31).
29).
Component replacement procedures
Spare part number
L32557-001
L32553-001
L28685-001
L32559-001
L32558-001
L32560-001
L32555-001
L32554-001
L32556-001
33