Smart Card Reader - HP ZBook 14u G6 Maintenance And Service Manual

Smart card reader

Table 6-11 Smart card reader and cable descriptions and part numbers
Description
Smart card reader
Smart card reader pass-thru board (for use in models without a smart card)
NOTE: This board provides cable pass through capability for models without a smart card.
Smart card reader cable (available in Cable Kit)
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the smart card reader:
NOTE: Before you remove the smart card reader, make sure nothing (memory card or plastic insert) in
inserted in the reader.
1. Disconnect the system board cable from the connector on the smart card reader board (1).
2. Disconnect the touchpad cable from the ZIF connector on the smart card reader board (2).
3. Remove the three Phillips M2.0 × 2.0 screws (3) that secure the smart card reader to the computer.
4. Remove the smart card reader from the computer (4).
Reverse this procedure to install the smart card reader.
60 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page 46).
34).
34).
Spare part number
L62733-001
L62743-001
L62734-001 (Cable Kit)