junger C8702 Manual page 23

digital audio
modular
processing system
Enhanced bit transparent mode
The SDI I/O or AES modules generate a non audio flag that indicates if the de-embedded data are
marked as non audio.
Important Note! This information does not mean that there is no signal.
This is the case for coded signals like Dolby E or Dolby Digital (AC3) or similar formats.
These are data streams sent over two ordinary digital audio channels as a transport media.
Audio processing equipment must not modify such data stream. Therefore you may turn the signal
chain into the Bit Transparent mode.
In the past, the knowledge about such data streams came from external equipment or was gathered
from play lists of automation systems.
Now the Junger processing channnel may be set up to Bit Transparent mode = [off / on / auto]:
In "auto" mode the module detects the non audio flag and will then pass the stream through the
processing module without touching it to avoid damage to the data structure.
You may also turn it "on" manually or via a preset for external control.
C8000
Frame Controller
C8702
Page 23/23