Installation - junger C8702 Manual

digital audio
modular
processing system

Installation

Location of labels and switches on the C8702 module.
The default IP address label is located on the "Coldfire" chip of the controller module
and on the front panel of the module.
While the MAC address is printed on a label here:
The FAIL LED flashes red if a power failure is detected on the carrier board.
SW1 #1
Set SW1 #2
Set SW1 #3
Set SW1 #3&#4 <C> and <D> to ON
SW2 #1 - #3 <DEV 0> / <DEV 1> / <DEV 2> must be ON
Set SW2 #4
C8000
Frame Controller
GND
<A> must be OFF
<B> to ON (all other to OFF) if only one power supply is installed.
<C> to ON (all other to OFF) if the Frame Controller is installed in a
C8942 frame.
(all other OFF) if the Frame Controller is installed
in a C8912 frame.
<CAN-TERM> to ON (terminate the CAN bus) if no sync module is installed.
If a brx 8x remote panel is connected, it must be off.
C8702
SW1
A
B
C
D
SW2
DEV 0
DEV 1
DEV 2
CAN-TERM
FAIL
Page 2/23