junger C8702 Manual page 17

digital audio
modular
processing system
Modules firmware update
Modules firmware update will normally be done via the Bulk Updater software.
If there is the need for special firmware combinations or you don't want to use the latest firmware for
any reason, you can make use of the MODULE FIRMWARE SINGLE UPDATE function. This function
gives you a drop down list of the modules of a frame, their addresses and their actual firmware.
Important Note! Before you update any module firmware and a new image comes with the module
firmware archive, you must update the Frame Controller. Otherwise the GUI may show incorrect module
control pages or the module is displayed in orange or red color.
This is a basic tool and it needs a bit of care when using it. You must update module by module and for
each module you must choose the respective part of the firmware, all one by one.
Select module to update
Select firmware to update
Select firmware file
Important Note! It is not possible to select a firmware file directly from an archive folder.
You must unpack that archive in order to use the individual firmware file(s).
C8000
Frame Controller
[address:type actual firmware] module name
module controller firmware is indicated by C:xx
DSP firmware is indicated by DSP:xx
FPGA firmware by FPGA:xx
SDI firmware is indicated by SDI:xx
NXP processor based modules C:xx DSP:xx FPGA:xx
[Controller (*.bin)]
[DSP (*.can)]
[FPGA (*.pga)]
[SDI (*.sdi)]
[Controller, DSP, FPGA, SDI (*.nxp)]
You must browse for the location of the respective file
(where you have unpacked the archive or where a single file
received from Junger is stored).
C8702
Page 17/23