junger C8702 Manual page 22

digital audio
modular
processing system
Monitoring the processing status of a processing module
The major parameter of the audio processing is the momentary GAIN of the module. This gain is
permanently changed by an adaptive dynamic process like LevelMagic™. If this gain sticks at one end
of its working range for too long, the settings of the processing parameters should be checked.
For the Level Magic process we have defined the "stick" condition as follows:
If the low pass weighted average gain of the process is equal or above the Leveler max Gain for
more than 10 secs. the respective
(see status panel left hand side):
The monitoring of the processing status may be turned
"Proc Status Monitor" above. It is important to turn it off if a processing channel is not in use or the
leveler max gain settings are too low for good reasons so it will cause an error by definition.
This will prevent the system from generating unfounded alarms (if the bad condition is monitored by an
external entity).
C8000
Frame Controller
Processing Status soft LED will turn from green to red
[ON / OFF] via the respective check boxes:
C8702
Page 22/23