junger C8702 Manual page 16

digital audio
modular
processing system
Possible problems when updating from older Frame Controller firmware
If you can not reach the GUI via an actual browser you must do a little trick to update the frame
controller. You must reboot the C8702 by briefly pressing the <INIT> button (or rebooting it from the
console interface). After approx. 60sec (boot up time) you should open the browser again and enter the
URL:
The following page will open:
Proceed with the image update as described above. When finished you will get a pop up, saying the
update was o.k. (it takes approx. 4 - 5 mins – be patient pls.).
Important Note! There was a change in the way the Frame Controller image is sent from the PC
to overcome a possible bottleneck of non-fragmented RAM. If you update from an older version (< 2660)
you should reboot the Frame Controller before starting the image update. This will ensure that there is
enough non-fragmented RAM for the existing update procedure.
If the Frame Controller reboots with the old firmware you must use the "-a" image:
(example) "rel_c8702_1_17_8-28002-a.img".
In rare events (if you come from a very old firmware it might be necessary that the update is performed
in a two tier approach: First use the "minimal" image:
"rel_c8702_minimal_image_1_0_1-30583.img" (the image number may change over time) and as a
second step update the actual release.
C8000
Frame Controller
http://<C8702-IP-address>/standalone-update.html
C8702
Page 16/23