Selecting Services - junger C8702 Manual

digital audio
modular
processing system
Setting of CAN BUS speed
You can select between the two CAN bus speeds: Normal (125kBit/s) or High (1Mbit/s) and the
Automatic detection of the installed modules.
Important Note! Don't mix up modules which are set to different CAN bus speeds.
High speed CAN bus is

Selecting services

For special applications you may activate the following services:
Maintenance Interface via RCP is for internal use only.
Telnet Server
BRC Proxy
Enable EmBER protocol support
VSM Support / Ember enabled You may directly connect with a VSM application or use the
Ember or Ember+ protocol to remote control the c8k frame.
For details of the VSM system see
and for Ember code depository go to:
Important Note! Right now we support both, the old Ember and the Ember+ protocol. It is our intention to
remove the old Ember server as soon as VSM fully supports Ember+.
We highly recommend you base your implementation on Ember+.
C8000
Frame Controller
only available for C8491, C8492, C8492(B) and C8817-3.
For remote access to the console interface via TCP/IP you must enable the Telnet
Server (TCP port 22).
If a brc 8x is connected via the CAN bus one must activate this option. Compared
with previous implementation, the brc remote panel no longer talks to the modules
directly. A proxy instance is used as the "man in the middle".
http://www.l-s-b.de/uk
http://code.google.com/p/ember-plus/
C8702
Page 12/23