System Backup And Restore - junger C8702 Manual

digital audio
modular
processing system

System backup and restore

For safety reasons or when doing module firmware updates you may want to backup the on air
parameters and presets of the modules in a frame:
When you press <BACKUP> the frame controller will gather all information stored in individual
modules of the frame and will build an XML file that contains such information. Due to the size of the
frame and the complexity of the modules installed it may take a little while. When it's done you will be
notified by a pop up. You must select "save file", press <OK> and a file dialog will open.
If you drop the preset content of the modules the process will be much faster.
In this case you must check the "Don't Backup Presets (faster)" option.
If you want to restore settings of a whole frame you must browse for a backup file stored on the PC
and press <RESTORE>:
"Don't Restore Frame Controller IP Configuration" option:
If the backup file is from a different frame but with the same configuration or from a partially equipped
frame from the test bench, you can prevent overwriting your current frame IP address by the one from
the backup file.
C8000
Frame Controller
C8702
Page 19/23