Display Assembly - HP ENVY 13 Maintenance And Service Manual

Display assembly

Description
13.3-in, UHD, BrightView, TouchScreen display assembly in natural silver finish
13.3-in, UHD, BrightView, TouchScreen display assembly in pale gold finish
13.3-in, FHD, BrightView, TouchScreen display assembly in natural silver finish
13.3-in, FHD, BrightView, TouchScreen display assembly in pale gold finish
13.3-in, UHD, BrightView, flush glass, non-TouchScreen display assembly in natural silver finish
13.3-in, UHD, BrightView, flush glass, non-TouchScreen display assembly in pale gold finish
13.3-in, UHD, BrightView, non-TouchScreen display assembly in natural silver finish
13.3-in, UHD, BrightView, non-TouchScreen display assembly in pale gold finish
13.3-in, FHD, AntiGlare, non-TouchScreen display assembly with privacy filter in natural silver finish
13.3-in, FHD, BrightView, flush glass, non-TouchScreen display assembly in natural silver finish
13.3-in, FHD, BrightView, flush glass, non-TouchScreen display assembly in pale gold finish
13.3-in, FHD, BrightView, non-TouchScreen display assembly in natural silver finish
13.3-in, FHD, BrightView, non-TouchScreen display assembly in pale gold finish
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the display assembly:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
WLAN antenna cable labeled "2/AUX" connects to the WLAN module "Aux" terminal.
2. Release the ZIF connector (2) to which display webcam/microphone cable is connected, and then
disconnect the display webcam/microphone cable from the system board.
3. Release the display webcam/microphone cable from the retention clips (3) and routing channels built into
the keyboard/top cover.
4. Release the adhesive strip (4) that secures the display panel cable to the system board.
5. Release the ZIF connector (5) to which display panel cable is connected, and then disconnect the display
panel cable cable from the system board.
Bottom cover on page
The WLAN antenna cable labeled "1/MAIN" connects to the WLAN module "Main" terminal. The
26).
Battery on page 27).
Component replacement procedures
Spare part number
L19539-001
L19756-001
L19537-001
L19754-001
L19534-001
L19752-001
L19538-001
L19755-001
L19535-001
L19533-001
L19751-001
L19536-001
L19753-001
45