Exit Sensor A Setup; Sensor B; Setting Up The Outputs - Honeywell T775U2006 Installation Instructions Manual

1. SETUP
Fig. 33. Setup - Sensors - Sensor A - Exit.
SETUP
Fig. 34. Setup - Sensors - Sensor B Menu.
SETUP
OUTPUTS
MOD 1
Fig. 35. Setup - Outputs Menu.
SETUP
SENSORS
SENSOR A
UNITS
CALIBRATE
LABEL
EXIT
SETUP
SENSORS SENSORS
# SENSORS
SENSOR A

SENSOR B

EXIT
SETUP
OUTPUTS
MOD 1
TYPE
MIN OUT %
INTEGRAL
DERIVATIV
SCHEDULE
RESET
HIDE
EXIT

1.2.2.5. Exit Sensor A Setup

Press the button to exit Sensor A selections and return
to the Sensors menu.
or
Use the and
button.
Continue with "1.2.3. SENSOR B (Temperature only)"
M24596
1.2.3. SENSOR B (Temperature only)
For two-sensor reset control, Sensor B must always be
the controlling temperature. For example, in a reset
control based on outside temperature, Sensor B must be
the outside sensor.
NOTE: Sensor B is available only for reset on the
T775U2006, but can be controlled just like Sen-
sor A on the T775U2016.
1. From the Sensors menu, use the
light SENSOR B.
M24597
2. Press the
3. Repeat the selections described in "1.2.2. SENSOR
A" through "1.2.2.4. LABEL (Sensor A or B input)"
beginning on page 14, but perform only those steps
applicable to Sensor B.
4. Press the
the Sensors menu.
or
Use the
press the
5. Press the
return to the Setup menu.
Continue with "1.3. Setting up the Outputs".

1.3. Setting up the Outputs

1. From the Setup menu, use the
highlight OUTPUTS.
2. Press the
NOTE: The menus (e.g. the Outputs menu shown here)
can display only those relays that are defined in
Setup (see page 21). For example, if you config-
ure only two relays, then only two relays display
on the appropriate menus.
M24599A
The following procedures set up each modulating output
and relay output.
17
T775U SERIES 2000 CONTROLLER
buttons to highlight EXIT and press the
button to display the Sensor B menu.
button to exit SENSOR B and return to
and buttons to highlight EXIT and
button.
button to exit the Sensors menu and
and
button to display the Outputs menu.
button to high-
buttons to
62-0255–05