Runco 1080p Owner's Operating Manual page 99

Table 5-2. VX-44d/-55d Error Codes (continued)
Code
60 Boot code CRC failed.
61 Unable to program DigMux PLD.
62 Unable to program Control PLD.
63 Unable to program Bubks PLD.
64 Unrecognized ROM type.
65 Write to flash ROM failed.
66 TIPM failure.
67 Downloaded code will not fit.
68 Scaler communication problem.
70 Unable to access EEPROM on the built-in keypad.
71 EEPROM memory re-initialization on the built-in keypad.
80 Unrecognized Panel Driver.
81 Unable to program device on Panel Driver.
82 TI flash download failure.
83 TI flash download failure.
84 TI flash download failure.
85 TI-I2C write failure.
86 One or more formatters not responding; probable formatter software fault.
87 Formatter reports RDRAM failure.
88 Red modular Formatter communication failure.
89 Green modular Formatter communication failure.
8A Blue modular Formatter communication failure.
93 Modular formatter architecture error.
94 Modular formatter DMD mismatch.
95 Modular formatter sequence mismatch.
Note: To clear a system error, press the EXIT key (on the projector's rear-panel keypad) twice. If
necessary, reset the projector by powering it off, allowing it to cool and powering it on again.
Contact your Runco dealer or Runco technical support if the error persists.
Runco VX-44d/-55d Owner's Operating Manual
Description
TIPM (Image Processor)
Built-In Keypad
Panel Driver and Formatter
87
Maintenance and Troubleshooting