Runco 1080p Owner's Operating Manual page 100

Maintenance and Troubleshooting
Table 5-2. VX-44d/-55d Error Codes (continued)
Code
A0 Unable to program the optional module.
A1 Unable to power the optional module.
A2 Unable to program the Dual Slot Backplane Module (DSBP).
A3 Unable to program the optional Post Processing Module (Warp module).
Note: To clear a system error, press the EXIT key (on the projector's rear-panel keypad) twice. If
necessary, reset the projector by powering it off, allowing it to cool and powering it on again.
Contact your Runco dealer or Runco technical support if the error persists.
Description
Miscellaneous
88 Runco VX-44d/-55d Owner's Operating Manual