Runco 1080p Owner's Operating Manual page 89

• Side Bar Color: This controls the color of the inactive image area. The range is from
-100 (black) to 100 (white).
The inactive image area is on either side of the active image area when using the
Standard 4:3 aspect ratio, and above and below the active image area when using the
Letterbox aspect ratio.
• Film Mode: Enable Film Mode to smooth out moving images from interlaced,
standard-definition (SD) sources. In most cases, the DHD Controller detects the proper
"pull-down" rate and vertical frequency. However, if your source is jittery and/or tearing
you may wish to enable Film Mode to ensure stable processing for that source.
Resolution: When using the VX-44d/-55d with a computer or certain HD sources, you
may want to force the DHD Controller to use a specific output resolution. If so, select
Resolution from the Service menu and choose one. Then, press ENTER to confirm.
System Reset: To reset ALL projector and controller settings (including image settings)
back to their factory defaults, choose System Reset from the Service menu.
A confirmation message appears, reminding you to save your settings before you perform
the reset, so that you can restore them afterwards. If you have done this, select Confirm to
continue with the reset. Otherwise, click Back to cancel.
This action is not undoable. Proceed with caution! Before you
Caution
perform a System Reset, save ALL settings, including "Custom" ISF
Presets (page 71), ISF Day/Night presets (page 73), Output Shift
settings (page 73), Input Names (page 74) and Trigger settings
(page 76).
Restore Saved Settings: Following a System Reset, select Restore Saved Settings to
apply all previously-saved settings to the projector and DHD Controller.
Runco VX-44d/-55d Owner's Operating Manual 77
Operation