Disassembly Instructions; Detaching Method Of The Terminal With Locking Mechanism; Removing The Cabinet And The Panels - Mitsubishi Electric MXZ-2F33VF-E1 Service Manual

13

DISASSEMBLY INSTRUCTIONS

<Detaching method of the terminal with locking mechanism>
The terminal which has the locking mechanism can be detached as shown below.
There are following 2 types of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
13-1. MXZ-2F33VF MXZ-2F42VF MXZ-2F53VF MXZ-2F53VFH
NOTE: Turn OFF the power supply before disassembly.
OPERATING PROCEDURE

1. Removing the cabinet and the panels

(1) Remove the screws fixing the service panel.
(2) Pull down the service panel and remove it.
(3) Disconnect the power supply and indoor/outdoor connect-
ing wire.
(4) Remove the screws fixing the top panel.
(5) Remove the top panel.
(6) Remove the screws fixing the cabinet.
(7) Remove the cabinet.
(8) Remove the screws fixing the back panel.
(9) Remove the back panel.
Photo 2
Screws of
the cabinet
OBH790
(2) The terminal with the connector shown below
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Photo 1
Screws of the
back panel
Photo 3
86
has the locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
PHOTOS
Screws of
the top panel
Hooks
Screws of
the back panel
Direction
to remove
Screws of
Service
panel