FOR INSTALLER Required Tools for Installation CONTENTS Phillips screwdriver Level 1. BEFORE INSTALLATION ............1 Scale 2. OUTDOOR UNIT INSTALLATION ..........7 3. FLARING WORK AND PIPE CONNECTION....... 8 Torque wrench 4. PURGING PROCEDURES, LEAK TEST, AND TEST RUN..9 5.
This manual only describes the installation of outdoor unit. When installing the indoor unit, refer to the installation manual of indoor unit. CAUTION Install an earth leakage breaker depending on the installation place. Do not install the outdoor unit where small animals may live. Perform the drainage/piping work securely according to the installation manual.
Page 4
FREE SPACE REQUIRED AROUND OUTDOOR UNIT Obstacles above Front (blowing) side open When there is no obstacle in front and on As long as space indicated in the the sides of the unit, it is allowed to install the unit where an obstacle is above the install the unit where obstacles are behind and on the sides of is provided.
Page 5
1-4-1. Minimum installation area for Outdoor units...
1-5. INSTALLATION DIAGRAM PARTS TO BE PROVIDED AT YOUR SITE is no gap. When the piping is to be attached to Wall hole cover Piping tape ing or wrap 7 to 8 turns of insulation Little Open as a rule Refrigeration oil the front and both sides are open...
Need help?
Do you have a question about the MXZ-2F53VFHZ and is the answer not in the manual?
Questions and answers