How To Set Up And Control The Unit - JB Systems RAVE SPOT Operating Manual

ENGLISH

HOW TO SET UP AND CONTROL THE UNIT

You can operate the unit in 4 ways:
1) MUSIC CONTROLLED MODE:
The unit runs a preprogrammed sequence to the
rhythm of the music. Select this mode when only 1 unit
is used (standalone) or when the unit is placed as the
first (master) unit in a chain with several units.
• Press the [MENU] button until the display shows:
[Sou]
• Now use the [UP] or [DOWN] to browse the different
sound modes.
• Press the [ENTER] button to select the desired
sound mode:
• With the [UP] & [DOWN] buttons, you can choose
different programs for the selected sound mode. (see
above)
• Press the [ENTER] button to confirm your choice.
• Put on some music and set the sensitivity of the
microphone by using the sensitivity knob (11) so that
the effect reacts perfectly to the sound level of your
music.
You can connect several units together: just put the first
unit of the chain in one of the sound activated effect
modes and all other units in "Slave mode" (display
shows "SLA") to make them all work in perfect sync!
Note: When no music is detected, the output of the unit
will be shut off (blackout).
2) FULL AUTOMATIC MODE:
The unit automatically
sequence. Select this mode when only 1 unit is used
(standalone) or when the unit is placed as the first
(master) unit in a chain with several units.
• Press the [MENU] button until the display shows [Aut]
• Now use the [UP] or [DOWN] to browse the different
automatic modes.
• Press the [ENTER] button to select the desired
automatic mode:
• With the [UP] & [DOWN] buttons, you can choose
different programs for the selected sound mode. (see
above)
• Press the [ENTER] button to confirm your choice.
• Now use the [UP] or [DOWN] buttons to select the
speed:
o
S 1 = Slowest speed
o
S 100 = Fastest speed
• Press the [ENTER] button to confirm your choice.
You can connect several units together: just put the first
unit of the chain in one of the automatic effect modes and all other units in "Slave mode" (display shows
"SLA") to make them all work in perfect sync!
3) SLAVE MODE:
The unit follows the instructions given by the first unit (master) in the chain. Like this you can obtain nice
synchronized shows.
• Connect the DMX input of the unit to the DMX output of the previous unit in the chain.
JB SYSTEMS®
runs a preprogrammed
5/12
USER MANUAL
RAVE SPOT