JB Systems RAVE SPOT Operating Manual page 8

ENGLISH
• Press the FUNC-button until the display shows [SLA]
• Press the ENTER-button to confirm your choice.
You can connect several units together. Please put the first unit of the chain in "Music or automatic mode"
and all other units in "Slave mode" to make them all work in perfect sync!
4) DMX512 MODE:
The projector can be controlled by any standard DMX-controller in 6 different DMX-modes.
• Press the [MENU] button until the display shows [dMH]
• Press the [ENTER] button
• The display will show the actual DMX address
• Press [ENTER] to enter the setup
• Use the [UP] or [DOWN] buttons to select the DMX mode you want to use. [1Ch], [2Ch], [4Ch], [6Ch],
[9Ch] or [22Ch]
• Press the [ENTER] button to confirm your choice.
• Use the [UP] or [DOWN] buttons to select the desired DMX address
• Press the [ENTER] button to confirm the DMX address
Note: the display blinks when the unit is in DMX-mode and no DMX-signal is detected.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light
equipment. You need to "daisy chain" your DMX controller and all the connected light
effects with a good quality XLR M/F balanced cable. To prevent strange behavior of the
light effects, due to interferences, you must use a 90Ω to 120Ω terminator at the end of
the chain. Never use Y-splitter cables, this simply won't work!
Each effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
JB SYSTEMS® 6/12
USER MANUAL
RAVE SPOT