Maintenance; Troubleshooting; Specifications - Royal Sovereign RSC Series Owner's Manual

14. MAINTENANCE

Cleaning the Body of the laminaor
1. To clean the machine body, dampen a cloth with water only and gently wipe the machine clean.
Removing Adhesive Build Up
1. Remove the film from the laminator.
2. Use a damp (water only) cloth and a rubber gum eraser to remove the adhesive on the
Teflon (metal) and silicone rollers.
Note: Rub firmly but do not scrub the rollers vigorously as this may scratch the
surface.Do not use sharp metal objects, steel wool, or abrasives, as these
may also damage the rollers.
Lubrication
1. Drive chain and sprockets should be lubricated with either a light coat of gear lube or
heavy grease (lithium grease) after 6 months or 1000 hours of operation, whichever
comes first.

15. TROUBLESHOOTING

Problem Cause
a. Power plug is not plugged in.
Machine will not turn b. Power switch is in "0" (Off) position.
on: c. Tripped circuit breaker.
d. Blown main power fuse.
a. Emergency switch (es) is (are)
There is power, but the
engaged.
rollers are not turning
b. Paper guide is not installed correctly.
after the "RUN" button
is pressed:
c. Blown motor fuse.
The unit is not heating
a. Did not raise the temperature.
up:
a. Upward curl.
Curled lamination:
b. Downward curl.
Solution
a. Plug the power cord into appropriate
outlet.
b. Put the power switch to the "I" (On)
position.
c. Reset the circuit breaker.
d. Replace the fuse.
a. Disengage the emergency switch (es).
b. Properly install the paper guide so that
the micro switch is activated.
c. Replace the motor fuse.
a. Raise the temperature.
a. Loosen the top roll film tension.
b. Loosen the bottom roll film tension.
17

16. SPECIFICATIONS

18
RSC Series