Table of Contents
Advertisement
Installation Instructions
UNPACKING THE WASHING MACHINE
Unpack your washing machine and check if there
is any damage during the transportation. Also
make sure that all the items in the attached bag are
received.
If there is any damage to the washing machine during
the transportation, or any item is missing, please
contact the local dealer immediately.
DISPOSAL OF THE PACKAGING MATERIALS
The packing materials of this machine may be
dangerous to children. Please dispose of them
properly and avoid contact with children. Please
dispose of the related packing materials according
to the relevant local regulations. Please do no throw
the packing materials away together with other daily
household waste.
REMOVE TRANSPORT BOLTS
Before using this washing machine, transport bolts
must be removed from the backside of this machine.
Please take the following steps to remove the bolts:
1.
Loosen all bolts with spanner and then remove
them.
2.
Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
SELECT THE LOCATION
Before installing the washing machine, please
consider the location for the following;
•
Rigid, dry, and level surface (if not level, please
make it level with reference to the following
figure "Adjust Leg")
•
Avoid direct sunlight
•
Sufficient ventilation
•
Room temperature is above 0 C
•
Keep the washing machine away from
combustible materials.
•
Make sure that the washing machine does not sit
on the power cord.
•
Do not install the washing machine on carpet
flooring.
ADJUST LEG
1.
When positioning the washing machine, please
first check if the legs are closely attached to the
cabinet. If not, please turn them to their original
positions with hand or spanner and tighten the
nuts with spanner.
2.
After positioning the washing machine, press
four corners on top cover of washing machine in
sequence.
If the washing machine is not stable when being
pressed, this leg shall be adjusted.
3. Ensure the positioning status of washing
machine. Loosen the lock nut with spanner and
turn the leg with hand until it closely contacts
with the floor. Press the leg with one hand and
fasten the nut closely to the cabinet with the
other hand.
4. After being locked properly, press four corners
again to make sure that they has been adjusted
properly. If it is still unstable, repeat Steps 2
and 3.
5. Ensure the machine is level, otherwise repeat
steps 1-3.
CONNECT INLET PIPE
Connect the inlet pipe as indicated in the figure.
For the model which has hot valve , please connect
the hot valve to hot water tap. Energy will decrease
automatically for some program.
6
Advertisement
Table of Contents
