Silvercrest SWK 360 A1 Operating Instructions And Safety Instructions page 45

♦ Align the helmet mount
♦ Pull the strap tight on both sides and push the clamps downwards.
The helmet mount must sit firmly on the helmet.
♦ Adjust if required so that the straps are pulled tight.
♦ Place the thread
tight.
1. 1.
4. 4.
2. 2.
3. 3.
Fig. 13
NOTE
► You can also install the helmet mount
► Extend the plug connectors
adapter
Optionally, you can use the following accessories for installation of the helmet mount
(+)
SWK 360 A1
so that it is straight on the helmet.
on the camera onto the fixture of the ball adapter
1. 1.
2. 2.
3. 3.
/ /
.
(+)
4. 4.
using the plug connector
as required or use the plug connector to ball joint
+
and screw the camera
.
:
+
GB│IE│NI 41
│
■