Silvercrest SWK 360 A1 Operating Instructions And Safety Instructions page 51

Variant B plug connector
You will need the following accessories to install the rod mount
(+)
♦ Select one of the plug connectors
♦ Push the plug connector
♦ Put the screw back into the mount and then tighten it again.
NOTE
► Extend the plug connectors
adapter
♦ Undo the screw on the plug connectors
♦ Push the plug connector
♦ Put the screw back into the mount and then tighten it again.
♦ Place the thread
camera tight.
SWK 360 A1
:
(+)
/ /
/ /
.
into the fixture.
of the camera onto the fixture of the plug connector
+
/ / .
into the fixture.
as required or use the plug connector to ball joint
/ / and remove it completely from the mount.
:
+
and screw the
GB│IE│NI 47 ■
│