Table of Contents
Advertisement
Chapter 4: BIOS
NVMe Firmware Source
This feature determines which type of the NVMe fi rmware should be used in your system.
The options are Vendor Defi ned Firmware and AMI Native Support.
VGA Priority
This feature selects the graphics device to be used as the primary video display for system
boot. The options are Auto, Onboard and Offboard.
CPU1 Slot1 PCI-E 3.0 x16 OPROM/CPU1 Slot2 PCI-E 3.0 x8 OPROM/ Slot/SIOM: CPU1
PCI-E 3.0 x16 OPROM
Select EFI to allow the user to boot the computer using an EFI (Expansible Firmware Interface)
device installed on the PCI-E slot specifi ed by the user. Select Legacy to allow the user to
boot the computer using a legacy device installed on the PCI-E slot specifi ed by the user. The
options are Disabled, Legacy and EFI. (Note: Riser card names may differ in each system.)
Bus Master Enable
Select Enabled to enable the Bus Driver Master bit. The options are Disabled and Enabled.
Onboard NVMe1 Option ROM/Onboard NVMe2 Option ROM/Onboard NVMe3 OptionROM/
Onboard NVMe4 Option ROM
Select Disabled to deactivate the selected slot, Legacy to activate the slot in legacy mode,
and EFI to activate the slot in EFI mode. The options are Disabled, Legacy, and EFI .
Onboard Video Option ROM
Use this feature to select the Onboard Video Option ROM type. The options are Disabled,
Legacy and EFI.
Network Stack Confi guration
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unifi ed Extensible
Firmware Interface) for network stack support. The options are Enabled and Disabled.
*If "Network Stack" is set to Enabled, the following items will display:
Ipv4 PXE Support
Select Enabled to enable Ipv4 PXE boot support. If this feature is disabled, it will not create
the Ipv4 PXE boot option. The options are Disabled and Enabled.
Ipv4 HTTP Support
Select Enabled to enable Ipv4 HTTP boot support. If this feature is disabled, it will not create
the Ipv4 HTTP boot option. The options are Enabled and Disabled.
Ipv6 PXE Support
Select Enabled to enable Ipv6 PXE boot support. If this feature is disabled, it will not create
the Ipv6 PXE boot option. The options are Disabled and Enabled.
87
Advertisement
Table of Contents
