Appendix; Appendix A: Enclosure; Appendix B: General Care And Cleaning; Appendix C: Usb Disk Requirements - Owon SDS6062 Quick Manual

6. Appendix

Appendix A: Enclosure

Standard Accessories:

A pair of Passive probe: 1.2 m, 1:1 (10:1)

1x CD (PC link application software)

1x Power cord: up to the standards of the country in which it is used.

1x USB cable

1x Quick Guide
Options:

Battery

Appendix B: General Care and Cleaning

General Care
Do not store or leave the instrument where the liquid crystal display will be exposed
to direct sunlight for long periods of time.
Caution: To avoid any damage to the instrument or probe, do not exposed it to any
sprays, liquids, or solvents.
Cleaning
Inspect the instrument and probes as often as operating conditions require.
To clean the instrument exterior, perform the following steps:
1. Wipe the dust from the instrument and probe surface with a soft cloth. Do not
make any scuffing on the transparent LCD protection screen when clean the LCD
screen.
2. Disconnect power before cleaning your Oscilloscope. Clean the instrument with a
wet soft cloth not dripping water. It is recommended to scrub with soft detergent
or fresh water. To avoid damage to the instrument or probe, do not use any
corrosive chemical cleaning agent.
Warning: Before power on again for operation, it is required to confirm that
the instrument has already been dried completely, avoiding any
electrical short circuit or bodily injury resulting form the moisture.

Appendix C: USB Disk Requirements

The supported format of the USB disk: FAT32 file system, allocation unit size cannot
exceed 4K, mass storage USB disk is also supported. If the USB disk doesn't work
properly, format it into the supported format and try again. About the methods to
format the USB disk, refer to SDS Series Smart Digital Storage Oscilloscopes User
Manual.
6.Appendix
24