Table of Contents
Advertisement
12.9 Tank Emptying
Remove all accessories.
The cleaning function removes the
residual water from the water drawer.
Use the function after the steam cooking
function.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
The duration of the function is around 6
minutes.
The light in this function is off.
1. Put the baking tray on the first shelf
position.
2. Press
.
Remove the baking tray after the end of
the procedure.
12.10 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Hold the door trim (B) on the top
edge of the door at the two sides and
push inwards to release the clip seal.
2
B
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
12.11 Replacing the lamp
A
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The top lamp
1. Turn the lamp glass cover to remove
it.
1
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
WARNING!
Risk of electric shock.
The lamp can be hot.
ENGLISH
49
Advertisement
Table of Contents
