Electrolux EOB8857AAX User Manual page 51

Hide thumbs Also See for EOB8857AAX:
Table of Contents

Advertisement

Problem
The lamp does not oper‐
ate.
The display shows F111.
The display shows an error
code that is not in this ta‐
ble.
Steam and condensation
settle on the food and in
the cavity of the oven.
The descaling procedure is
interrupted before it finish‐
es.
The descaling procedure is
interrupted before it finish‐
es.
There is no water inside
the grill- / roasting pan af‐
ter the descaling proce‐
dure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The cleaning function is in‐
terrupted before it finishes.
The cleaning function is in‐
terrupted before it finishes.
There is too much water on
the bottom of the cavity af‐
ter the end of the cleaning
function.
Possible cause
The lamp is defective.
The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
There is an electrical fault.
You left the dish in the
oven for too long.
There was a power cut.
The function was stopped
by the user.
You did not fill the water
drawer to the maximum
level.
The grill- / roasting pan is
on a wrong shelf position.
There was a power cut.
The function was stopped
by the user.
You sprayed too much de‐
tergent in the appliance
before the activation of the
cleaning cycle.
ENGLISH
Remedy
Replace the lamp.
Put the plug of the core
temperature sensor as far
as possible into the socket.
• Turn off the oven with
the house fuse or the
safety switch in the fuse
box and turn it on again.
• If the display shows the
error code again, con‐
tact the Customer Care
Department.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roast‐
ing pan on the first shelf
position.
Repeat the procedure.
Repeat the procedure.
Cover all parts of the cavity
with a thin layer of the de‐
tergent. Spray the deter‐
gent evenly.
51

Advertisement

Table of Contents
loading

Table of Contents