Replacing The Lamp - Electrolux FQP95XEV User Manual

5. Hold the door trim (B) on the top
edge of the door at the two sides and
push inwards to release the clip seal.
2
B
6. Pull the door trim to the front to
remove it.
7. Hold the door glass panels by their
top edge and carefully pull them out
one by one. Start from the top panel.
Make sure the glass slides out of the
supports completely.
8. Clean the glass panels with water
and soap. Dry the glass panels
carefully.
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite
sequence.
Make sure that you put the glass panels
(A, B and C) back in the correct
sequence. The middle panel (B) has a
decorative frame. The screen-printing
zone must face the inner side of the
door. Make sure that after the installation
the surface of the glass panel frame (B)
on the screen-printing zones is not rough
when you touch it.
1
A B C
Make sure that you install the middle
panel of glass in the seats correctly.

10.8 Replacing the lamp

Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
ENGLISH 27
A
B
C