Hints And Tips - Electrolux EOB8857AAX User Manual

26 www.electrolux.com
10.4 Set + Go
The function lets you set a heating
function (or a programme) and use it
later with one press of any symbol.
1. Turn on the oven.
2. Set a heating function.
3. Press
display shows: Duration.
4. Set the time.
5. Press
display shows: Set + Go.
6. Press
Press any symbol (except for
the function: Set + Go. The set heating
function starts.
When the heating function ends, a signal
sounds.
• Function Lock is on when
• The menu: Basic Settings
10.5 Automatic Switch-off
For safety reasons the oven turns off
automatically after some time if a heating
function works and you do not change
any settings.
Temperature (°C) Switch-off time
30 - 115

11. HINTS AND TIPS

WARNING!
Refer to Safety chapters.
The temperature and baking
times in the tables are
guidelines only. They
depend on the recipes and
the quality and quantity of
the ingredients used.
again and again until the
again and again until the
to confirm.
the heating function
works.
lets you turn the function:
Set + Go on and off.
(h)
12.5
Temperature (°C) Switch-off time
120 - 195
200 - 230
10.6 Brightness of the display
There are two modes of display
) to start
brightness:
• Night brightness - when the oven is
turned off, the brightness of the
display is lower between 10 PM and 6
AM.
• Day brightness:
– when the oven is turned on.
– if you touch a symbol during the
– if the oven is turned off and you
10.7 Cooling fan
When the oven operates, the cooling fan
turns on automatically to keep the
surfaces of the oven cool. If you turn off
the oven, the cooling fan can continue to
operate until the oven cools down.
11.1 Cooking recommendations
Your oven may bake or roast differently
to the oven you had before. The below
tables provide you with the standard
settings for temperature, cooking time
and shelf position.
If you cannot find the settings for a
special recipe, look for the similar one.
(h)
8.5
5.5
The Automatic switch-off
does not work with the
functions: Light, Food
Sensor, Duration, End Time.
night brightness (apart from ON /
OFF), the display goes back to
the day brightness mode for the
next 10 seconds.
set the function: Minute Minder.
When the function ends, the
display goes back to the night
brightness.