Diagnostics; Function Indicators; Led Indicators; Status Leds - Balluff BNI PBS-507-001-Z011 User Manual

Balluff Network Interface Profibus
8

Diagnostics

8.1. Function
indicators

LED indicators

Status LEDs

IO-Link Port
LEDs

Diagnostics input

www.balluff.com
The status of the supply voltages is indicated by the status LED´s 1 to 5.
LED Indicator
US Green
UA Green
US Red
UA Red
BUS Green
Grün, blinking
Each IO-Link-port is assigned two LEDs which indicate the operating states.
LED "0" - PIN 4, LED "1" - PIN 2
Indicator
IO-Link
Off -
Yellow -
Red SC >Imax
IO-Link Commu-
Green
nication active
Green No IO-Link
blinking Communication
* SC = Short circuit detection on Pin 1. In this case both LEDs are red.
Pin 2 of the I/O port can be configured as a diagnostics channel It behaves like an inverted
input. The 0 V signal is interpreted as 1, the corresponding port LED comes n red and a
diagnostics message is sent over DP-diagnostics.
The optical indicator on the corresponding I/O port allows defective sensors/actuators to be
more easily and quickly localized.
Function
US power supply sensor ok
UA power supply actuator ok
US power supply sensor under voltage
UA power supply actuator under voltage
BUS data transmission Profibus ok
BUS data transmission Profibus inactive
Function
Output Input
Signal = 0 Signal = 0
Signal = 1 Signal = 1
I Output > Imax SC*
- -
- -
Diagnostic-Input
Diagnostics = 0
Diagnostics = 1 or SC*
-
-
26