Server Technology 4805-XLS-16B Installation And Operation Manual page 93

To display network configuration information:
At the Switched -48 VDC: prompt, type show network and press Enter.
Example
The following command displays the network configuration information:
Switched -48 VDC: show network<Enter>
Network Settings
State:
Link:
Speed:
AutoCfg IPv6: FE80::20A:9CFF:FE52:4104/64
IPv6 Address: FD01::1:B51A:E03C/64
IPv4 Address: 10.1.6.230 Subnet Mask: 255.255.0.0
IPv4 Gateway: 10.1.1.1
DNS1: FD01::A01:585
DNS2: 10.1.5.133
Static IPv4/IPv6 Settings
IPv6 Address: FD01::A01:353/64
IPv6 Gateway: ::
IPv4 Address: 10.1.2.253 Subnet Mask: 255.255.0.0
IPv4 Gateway: 10.1.1.1
DNS1: 10.1.5.133
DNS2: 10.1.5.134
DHCP Settings
DHCP: Enabled
FQDN: Enabled [sentry3-524104]
Boot Delay: Enabled
Static Fallback: Enabled
Network Services
Telnet:
SSH:
HTTP:
SSL:
Access:
User Cert: Enabled
SNMPv1/2: Enabled
SNMPv3: Disabled
FTP Server: Enabled
SPM Access: Enabled
Command successful
NOTE: The fields IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway, DNS1, and DNS2 are equivalent to existing CDU IPv4 settings except
that current network settings and static settings are displayed separately. This allows you to view both static configuration settings and active
network settings that can be obtained using DHCP. The DNS addresses can be IPv4 or IPv6 format at this time (based on RFC4291).
-48 VDC Remote Power Manager
Installation and Operations Manual
DHCP IPv6/IPv4
Up
100 Mbps
Enabled Port: 23
Enabled Port: 22
Enabled Port: 80
Enabled Port: 443
Optional
Port: 161
Port: 161
Port: 21
Network: Dual IPv6/IPv4
Negotiation: Auto
Duplex: Full
Auth: Password, Kb-Int
Installed Cert: User Encrypted
Stored Files: Cert & Key
User Passphrase: <set>
TrapPort: 162
TrapPort: 162
Operations  93