Server Technology 4805-XLS-16B Installation And Operation Manual page 19

Viewing Network Status
You can obtain the IPv6 network status through the firmware Web Interface or Command Line Interface (CLI). For the CLI,
use the show network command as follows:
Switched -48 VDC: show network
Network Settings
State: DHCP IPv6/IPv4
Link: Up
Speed: 100 Mbps
AutoCfg IPv6: FE80::20A:9CFF:FE52:4104/64
IPv6 Address: FD01::1:B51A:E03C/64
IPv4 Address: 10.1.6.230 Subnet Mask: 255.255.0.0
IPv4 Gateway: 10.1.1.1
DNS1: FD01::A01:585
DNS2: 10.1.5.133
Static IPv4/IPv6 Settings
IPv6 Address: FD01::A01:353/64
IPv6 Gateway: FD01::A01:353/64
IPv4 Address: 10.1.2.253
IPv4 Gateway: 10.1.1.1
DNS1: 10.1.5.133
DNS2: 10.1.5.134
DHCP Settings
DHCP: Enabled
FQDN: Enabled [sentry3-524104]
Boot Delay: Enabled
Static Fallback: Enabled
Network Services
Telnet: Enabled
SSH: Enabled
HTTP: Enabled
SSL: Enabled
Access: Optional
User Cert: Enabled
SNMPv1/2: Enabled
SNMPv3: Disabled
FTP Server: Enabled
SPM Access: Enabled
Command successful
NOTE: The fields IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway, DNS1, and DNS2 are equivalent to existing unit IPv4 settings except that current
network settings and static settings are displayed separately. This allows you to view both static configuration settings and active network settings that
can be obtained using DHCP. The DNS addresses can be in IPv4 or IPv6 (based on RFC4291) format at this time.
-48 VDC Remote Power Manager
Installation and Operations Manual
Network:
Negotiation:
Duplex:
Subnet Mask: 255.255.0.0
Port: 23
Port: 22 Auth: Password, Kb-Int
Port: 80
Port: 443 Installed Cert: User Encrypted
Stored Files: Cert & Key
User Passphrase: <set>
Port: 161 TrapPort: 162
Port: 161 TrapPort: 162
Port: 21
Dual IPv6/IPv4
Auto
Full
Introduction  19