Server Technology 4805-XLS-16B Installation And Operation Manual page 92

Setting the IP address:
The Set Ipaddress command sets the TCP/IP address of the network interface controller.
To set the IP address:
At the Switched -48 VDC: prompt, type set ipaddress, followed by the IP address and press Enter.
NOTE: Both IPv4 and IPv6 IP address formats are accepted.
Example
The following command sets the IP address to 12.34.56.78:
Switched -48 VDC: set ipaddress 12.34.56.78<Enter>
Setting the subnet mask:
The Set Subnet command sets the subnet mask for the network the PT40 will be attached to.
To set the subnet mask:
At the Switched -48 VDC: prompt, type set subnet, followed by the subnet mask and press Enter.
Example
The following command sets the subnet mask to 255.0.0.0
Switched -48 VDC: set subnet 255.0.0.0<Enter>
Setting the gateway:
The Set Gateway command sets the IP address of the default gateway the CDU uses to access external networks.
To set the gateway IP address:
At the Switched -48 VDC: prompt, type set gateway, followed by the gateway IP address and press Enter.
Example
The following command set the gateway IP address to 12.34.56.1:
Switched -48 VDC: set gateway 12.34.56.1<Enter>
Setting the DNS IP address:
The Set DNS command sets the TCP/IP address of the Domain Name server (DNS).
To set the DNS IP address:
At the Switched -48 VDC: prompt, type set, followed by dns1 or dns2 and the Domain Name server's IP address.
Press Enter.
NOTE: Both IPv4 and IPv6 formats are accepted for DNS IP address.
Example
The following command sets the primary Domain Name server IP address to 98.76.54.254:
Switched -48 VDC: set dns1 98.76.54.254<Enter>
Displaying network configuration information:
The Show Network command displays TCP/IP, Telnet, SSH, Web, SSL, SNMP, and DHCP options (when DHCP is enabled)
configuration information. The Show Network command also displays all IPv4 and IPv6 settings.

Network configuration: IP address, subnet mask, gateway and DNS IP addresses (both IPv4 and IPv6 formats
are displayed).

Enabled-disabled status and port numbers for Telnet, SSH, HTTP, SSL, SNMP, and FTP Server support.

Network status: Link, speed, duplex, and negotiation.

DHCP boot delay and DHCP static address fallback options (when DHCP is enabled).

Enabled-disabled status of Sentry Power Manager (SPM).
92  Operations
Installation and Operations Manual
-48 VDC Remote Power Manager