Power Connector Cable - HP ENVY x360 13 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the system board (see
Remove the power connector cable:
1. Position the system board with the power connector toward you.
2. Disconnect the power connector cable from the system board.
Reverse this procedure to install the power connector cable.
Bottom cover on page
Battery on page 27).
System board on page
25).
46).
Component replacement procedures
Spare part number
L19588-001
51