Memory Shield - HP ENVY x360 13 Maintenance And Service Manual

Memory shield

Description
Memory shield
IMPORTANT:
Before removing the memory shield, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the memory shield:
1. Lift the tape from the top of the shield (1).
2. Squeeze the shield to disengage it from clips on system board (2), and the remove the shield (3).
Reverse this procedure to install the memory shield.
To replace the memory shield, position the shield over the system board (1), align the bottom edges of the
cover with the small clips on the system board (2), and then insert the cover into the clips (3).
32 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
The memory is integrated into the system board and is not removable or upgradeable.
Bottom cover on page
Battery on page
25).
27).
Spare part number
L19789-001