Communication Hardware Solutions - ABB RED650 Applications Manual

Section 19
Remote communication
19.1.2.1
394
only place where the differential current is evaluated. If the evaluation results in a
trip, the trip signal will be sent over the two communication links.
3-end differential protection with two communication links
IED-A
Ldcm312
IEC16000077 V1 EN-US
Figure 164: Three-end differential protection with two communication links
If the LDCM is in 2Mbit mode, you can send the three local currents as well as the
three remote currents from the other links by configuring the transmitters in IED-B:
1. Ldcm312 transmitter sends the local currents and the three currents received
by Ldcm313.
2. Ldcm313 transmitter sends the three local currents and the three currents
received from Ldcm312.
As a result, six currents are received in IED-A and IED-C. These currents can be
connected to the protection function together with the local three currents.
In order to forward the logic signals (for example, inter-trip or inter-
block) between IED-A and IED-C, the setting LinkForwarded
should be defined. In IED-B, it is set to LDCM313 for Ldcm312
and to LDCM312 for ldcm313.
This setup results in a master-master-master configuration, but without the benefit
of reverting to a slave-master-slave configuration in case of a communication link
interruption. In case of a communication link interruption, all three IEDs would be
blocked.

Communication hardware solutions

The LDCM (Line Data Communication Module) has an optical connection such
that two IEDs can be connected over a direct fiber (multimode), as shown in figure
165. The protocol used is IEEE/ANSI C37.94. The distance with this solution is
typical 110 km.
Ldcm312
IED-B
Ldcm313
Line differential protection RED650 2.2 IEC
1MRK 505 393-UEN B
Ldcm312
IED-C
IEC16000077-1-en.vsd
M12844-11 v6
Application manual