KTM 1290 SUPER ADVENTURE R 2018 Owner's Manual page 65

The indicator lamps offer additional information about the operating state of the motorcycle.
When the ignition is switched on, all indicator lamps light up briefly.
Info
The malfunction indicator lamp always lights up as long as the engine is not running. If the engine is run-
ning and the malfunction indicator lamp lights up, stop (taking care not to endanger yourself or other road
users in the process) and contact an authorized KTM workshop.
The oil pressure warning lamp always lights up as long as the engine is not running. If the engine is run-
ning and the oil pressure warning lamp lights up, stop immediately (taking care not to endanger yourself or
other road users in the process) and switch off the engine.
The ABS indicator lamp and TC indicator lamp light up until a speed of approx. 6 km/h (approx. 4 mph) or
more has been reached.
Possible states
Race-on indicator lamp lights up/flashes yellow/orange/red – Status or error messages relating
to Race-on system/alarm system.
The left turn signal indicator lamp flashes green with a steady rhythmic flash – The left turn
signal is switched on.
The high beam indicator lamp lights up blue – The high beam is switched on.
The general warning lamp lights up yellow – An operating safety (warning note) message was
detected. This is also shown on the display.
ABS indicator lamp lights up yellow – Status or error messages relating to ABS. The ABS indi-
cator lamp flashes if the ABS mode Offroad is enabled.
COMBINATION INSTRUMENT 7
63