Dell PowerEdge R730xd Deployment Manual page 68

Parameter
Interface int-a netmask
Interface int-a IP Range
Interface int-b netmask
Interface int-b IP Range
Failover IP range
Interface ext-1 netmask
MTU
Interface ext-1 IP pool
ext-1 default gateway
SmartConnect Zone name
SmartConnect service IP
DNS servers
Search domain
Cluster date and time
Cluster join mode
Commit changes
Note: Additional information and configuration for SmartConnect will be provided in
When the first node is configured, and the cluster has been created, the other nodes can then be added into
the cluster. All nodes will be able to discover the cluster over the back-end network. The assorted options for
back-end networking and Isilon are not covered in this document, for more information on the back-end
network refer to Isilon documentation.
1. At the login screen of node two, select [ 2] Join existing cluster.
2. The cluster that was created will be displayed, select 1 to add node two to Cluster-01.
3. Repeat for all nodes that need to be added to the cluster. Each node will be dynamically assigned an IP
address out of the IP pool that was designated in the cluster creation.
68 Dell EMC Networking with Isilon Front-End Deployment and Best Practices Guide | version 1.0
Value
255.255.255.0
10.10.10.1-253
255.255.255.0
10.10.20.1-253
10.10.30.1-253
255.255.255.0
1500
100.67.170.140-148
100.67.170.254
Mgmtzone1
100.67.170.149
100.67.10.1
dell.local
Default
Default
Yes
Section 9.5.