B
EX 172.16.2.0/24
Note: The command show ip route <cr> can also be used to verify the information above as well as
static routes and direct connections.
8.1.3
Show VLT
This command is used to validate VLT configuration status on leaf switches in this topology. The VLTi Link
Status must be up. The role of one switch in the VLT pair is primary (not shown), and its peer switch is
assigned the secondary role. Ensure Peer-Routing is shown as enabled.
S4048-Leaf1# show vlt 127
Domain ID
Unit ID
Role
Version
Local System MAC address
VLT MAC address
IP address
Delay-Restore timer
Peer-Routing
Peer-Routing-Timeout timer : 0 seconds
VLTi Link Status
port-channel1000
VLT Peer Unit ID
--------------------------------------------------------------------------------
1
8.1.4
Show VLT backup-link
This command is used to verify that the back-up destination is set correctly and the peer heartbeat is up.
S4048-Leaf1# show vlt 127 backup-link
VLT Backup Link
------------------------
Destination: 100.67.170.14
Peer Heartbeat status: Up
8.1.5
Show vlt-port-detail
This command is used to validate VLT LAG status on leaf switches in this topology. This command shows the
status and active VLANs of all VLT LAGs. The local and peer status must both be up.
S4048-Leaf1# show vlt 127 vlt-port-detail
vlt-port-channel ID : 1
VLT Unit ID
60
Dell EMC Networking with Isilon Front-End Deployment and Best Practices Guide | version 1.0
via 192.168.1.0
via 192.168.2.0
: 127
: 2
: secondary
: 1.0
: 64:00:6a:e6:b6:14
: f4:8e:38:20:44:29
: fda5:74c8:b79e:1::2
: 90 seconds
: Enabled
: up
System MAC Address
f4:8e:38:20:44:29
Port-Channel
20/0
Status
IP Address
up
fda5:74c8:b79e:1::1
Status
Configured ports
01:00:11
Version
1.0
Active ports