Appendix 1; Firmware Upgrade - SmartWitness KP1S User Manual

Appendix 1

11. SPECIFICATIONS

Firmware Upgrade

1. To begin the firmware upgrade, you will need to install the KP1S Configuration
Tool software on your computer. The firmware must be provided by SmartWitness
technical support or your distributor. For full details on installation, please go to
section 4 on page 23.
2. Then, initialize your SD Card using the KP1S configuration software.
3. Make a folder called program" on the SD Card as shown below.
4. Copy the "KP1S_2.2.X.bin" file into the SD card's 'program' folder.
5. Make sure KP1S is turned off and insert the prepared SD card into KP1S SD
slot 1 and turn on the power.
Upgrading the unit will usually take about 1 to 2 minutes. The green & blue LEDs will
alternate during the firmware update process.
PLEASE NOTE
DO NOT TURN OFF THE POWER DURING UPGRADING.
If the upgrade fails, "KP1S" unit should be returned to your local distributor.
6. Once the upgrading is finished, KP1S will automatically boot to its programmed
recording settings.