Basic Operation; Automatic Start; Led Operation At Start-Up; G-Sensor Calibration - SmartWitness KP1S User Manual

2. BASIC OPERATION

Automatic Start

Plug the car charger cable into the cigarette lighter adaptor in your vehicle and KP1S
will start automatically.
However KP1S will not start recording immediately after the power has been turned
o n . It takes around 30-45 seconds for the built-in power backup system to be
charged. After this, the internal flash memory will be ready to record.
PLEASE NOTE
Please make sure to turn off the power of the KP1S when inserting or ejecting the SD
card and the USB 3G/WiFi dongle.

LED Operation at Start-up

Firstly, the Red LED will be ON (around 6 sec), then, Red LED (Warning) and Orange
LED will be ON (around 12 sec)
Red LED, Orange LED, Blue LED, Green LED will be ON in sequence
(around 40 ~ 50 sec)
Blue LED On/Off (Starting time: around 60 ~ 70 sec)
(Buzzer sound operation at start-up)
Single "Beep" after starting (If beep is set to 'On' in config settings).

G-Sensor Calibration

After installing KP1S, you will need to calibrate the G-Sensor. To do this, turn on
KP1S and park the vehicle on a flat surface. Then, press the [G-Sensor Calibration]
button for one second.
This G-Sensor calibration is only needed the first time KP1S is used.