Remote Configure - SmartWitness KP1S User Manual

When you have sent the email request, the KP1S will send the following email back
to the registered email address.
Email Subject:
ID>Vehicle ID >T>Date-Time
For example: ID > Y122 VVE > T > 2013/11/16-17:39:17
T= Thumbnail video
Attach AVI file (10sec, HD or 10sec VGA or 10sec QVGA): 1st camera only (Pre) 4
seconds + (Event)1 second + (Post) 5 seconds
The AVI file resolution can be set in the settings on the analysis software.
AVI file name: ID_Date_Time.avi
KML file name: ID_Date_Time.kml
- To Change KP1S Settings

Remote Configure

Send an Email to KP1S
Email Subject:
S_ >_Admin Password
For example: S_ >_555555
Attach setting.ini file
Note that this command requires you to enter the admin password and not the user
password that can be used in other requests.
To send the 'setting.ini file' use the config tool to adjust the settings to your
requirements and click the 'save' button and then 'select folder' button. This will
create the file that you can attach on the email to the KP1S and apply these settings
to the unit.
All commands have to be sent from one of the registered users that can be set in the
KP1S Configure Software.