Status Codes For Acyclic Services - Danfoss VLT Compact Starter MCD 201 Installation Manual

Packet Structures

7.3.3.3 Status Codes for Acyclic Services

Status Status name
code
0x00 Success
0x03 Invalid parameter value
0x05 Path destination unknown The mapped register does not exist.
0x08 Service not supported
0x09 Invalid attribute value
0x0E Attribute not settable
0x14 Attribute not supported
0x16 Object does not exist
Table 7.14 Status Codes, Get/Set Attribute Single
MG17Q102
Installation Guide
Comments
This code is returned after successful execution of the service, that is
•
When the register mapped for service Get attribute single is successfully read.
•
When the register mapped for service Set attribute single is successfully set.
–
The requested service is not available for this Object class/instance.
This code only applies to the service Set attribute single. It is returned if the value is out of range
for the mapped register.
This code only applies to the service Set attribute single. It is returned if the mapped register is
read-only.
The attribute specified in the request is not supported.
The object specified does not exist in the device.
Danfoss A/S © 05/2017 All rights reserved.
7 7
21